Banner U-Gage Ultrasonic Sensor Manual de usuario Pagina 40
- Pagina / 66
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
LIGHT GAUGING
ULTRASONIC
QT50U
S18U
QS18U
T30U/T30UX
M25U
T18U
Q45U
Q45UR
MEASURING
ARRAYS
RADAR
More information online at bannerengineering.com 331
Photoelectrics
Sensors
Fiber Optic
Sensors
Special Purpose
Sensors
Measurement &
Inspection Sensors
Vision
Wireless
Lighting &
Indicators
Safety
Light Screens
Safety
Laser Scanners
Fiber Optic
Safety Systems
Safety Controllers &
Modules
Safety Two-Hand
Control Modules
Safety Interlock
Switches
Emergency Stop &
Stop Control
U-GAGE
®
T18U Specifications
Sensing Range
(no minimum range)
NORMAL resolution mode: to 600 mm
HIGH resolution mode: to 300 mm
Supply Voltage and Current
12 to 30V dc, 10% max. ac ripple.
50 mA (emitters); 35 mA (receivers), exclusive of output load.
Ultrasonic Frequency
230 kHz
Minimum spacing
(adjacent pairs)
50 mm for emitter-to-receiver separations of up to 150 mm.
Add 10 mm of adjacent-pair spacing for every 100 mm of emitter-to-receiver spacing beyond 150 mm.
Receiver Output
Configuration
T18VN models: NPN sinking, NO and NC (complementary)
T18VP models: PNP sourcing, NO and NC (complementary)
Receiver Output Rating
150 mA max. each output at 25° C, derated to 100 mA at 70° C (derate ≈ 1 mA per ° C).
Both outputs may be used simultaneously.
ON-state saturation voltage: less than 1.5V at 10 mA; less than 2.0 V at 150 mA
OFF-state leakage current: less than 1 µA at 30V dc
Output protection: Overload and short-circuit protected.
No false pulse upon receiver power-up: false pulse protection causes a 100 millisecond delay upon power-up.
Output Response Time
NORMAL resolution mode: 2 milliseconds ON/OFF
HIGH resolution mode: 1 millisecond ON/OFF
Rep Rate
NORMAL resolution mode: 125 Hz max.
HIGH resolution mode: 200 Hz max.
Mechanical Sensing
Repeatability at 300 mm range
NORMAL resolution mode: less than 2 mm
HIGH resolution mode: less than 1 mm
Beam Angle (-3dB full angle)
15 ± 2˚
Indicators
Emitters have a green LED for dc power ON. Receivers have two LED’s, one yellow and one green.
Green: power ON
Yellow: sonic signal received (ash rate is proportional to received signal strength; ash is from full to half intensity).
See data sheet for detailed information.
Construction
T-style yellow PBT polyester housing with black PBT polyester back cover. Transducer housing is threaded M18 x 1. Mating jam nut is
supplied for mounting. Acoustic face is epoxy reinforced. Circuitry is epoxy-encapsulated.
Environmental Rating
IEC IP67; NEMA 6P
Connections
Emitters: 2 m long attached PVC- covered 2-wire cable or 4-pin Euro-style quick-disconnect tting.
Receivers: 2 m long attached PVC-covered 4-wire cable or 4-pin Euro-style quick-disconnect tting.
9 m long cables are available by request.
Mating Euro-style quick-disconnect cordsets are also available. See page 331.
Operating Temperature
-40° to +70° C
Vibration and
Mechanical Shock
All models meets Mil.Std 202F requirements method 201A (Vibration: frequency 10 to 60 Hz, max., and double amplitude 0.06",
maximum acceleration 10G) and method 213B conditions H&I (Shock: 75G with unit operation; 100G for non-operation).
Also meets IEC 947-5-2 requirements: 30G, 11 milliseconds duration, half sine wave.
Certifications
Hookup Diagrams
Emitter Models: MI21 (p. 763) NPN Models: MI19 (p. 762) PNP Models: MI20 (p. 762)
Brackets
T18U
SMB18A SMB18155F SMB18FA..
pg. 637 pg. 637 pg. 638
Cordsets
Euro QD
See page 682
Length
Threaded 4-Pin
Straight Right-Angle
2 m MQDC-406 MQDC-406RA
5 m MQDC-415 MQDC-415RA
9 m MQDC-430 MQDC-430RA
Additional cordset information available.
See page 679.
Additional brackets and information available.
See page 620.
Courtesy of Steven Engineering, Inc.-230 Ryan Way, South San Francisco, CA 94080-6370-Main Office: (650) 588-9200-Outside Local Area: (800) 258-9200-www.stevenengineering.com
- MEASUREMENT & INSPECTION 1
- Light Gauging Sensors 2
- Measuring Light Screens 3
- Ultrasonic Sensors 3
- LIGHT GAUGING SENSORS 4
- LT3 Sensing Ranges 5
- LT3, 12-24V dc 6
- LT3 Specifications 6
- = Visible Red Laser 8
- 90% White to 18% Gray 8
- 90% White to 6% Black 8
- REFLECTORS 8
- Laser Gauging Sensors 9
- LT7, 18-30V dc 10
- LT7 Specifications 10
- (cont’d) 11
- Brackets 11
- Cordsets 11
- Actuators,Indicators 12
- & Illuminators 12
- Serial Adapters 13
- LH Specifications 13
- Short-range Laser Sensors 14
- LG5 and LG10 Specifications 15
- LG10, 12-30V dc 15
- ULTRASONIC SENSORS 17
- Long-Range Ultrasonic Sensor 18
- QT50U, 10-30V dc 19
- QT50U DC Specifications 19
- Effective Beam Patterns 22
- Compact Barrel-Mount 23
- Ultrasonic Sensor 23
- S18U Specifications 24
- S18U (Typical) 25
- S18U (with 500 mm Plate) 25
- Maximum Target Rotation Angle 25
- Ultrasonic WORLD-BEAM 26
- WORLD-BEAM 27
- QS18U Specifications 27
- Ultrasonic Wave Guides 28
- T30UX/T30U 29
- T30UX, 10-30V dc 30
- T30U, 12-24V dc 30
- ACCESSORIES 31
- T30UX Specifications 32
- T30U Specifications 33
- Stainless Steel Opposed-Mode 37
- M25U Specifications 38
- Opposed Dual Range Sensors 39
- T18U Specifications 40
- Flexible Ultrasonic Sensors 41
- Q45U Specifications 43
- bannerengineering.com 339 48
- Mini QD (With Shield) 48
- Euro QD (With Shield) 48
- MEASURING ARRAYS 49
- EZ-ARRAY 50
- bannerengineering.com 343 52
- Communication Cordsets 52
- See page 739 Model 52
- High-Resolution MINI-ARRAY 53
- bannerengineering.com346 55
- MINI-ARRAY 57
- bannerengineering.com 351 60
- Controller Specifications 61
- bannerengineering.com 353 62
- DB9 Communication 62
- Retroreective Sensors 63
- QT50R Specifications 64
- Web Only 66
Relacionado con productos y manuales para De medición, control y control Banner U-Gage Ultrasonic Sensor
(16 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.039 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales