Banner D11 Series Manual de usuario descargar pdf (Pagina 2)

D11 Series

page 2 Banner Engineering Corporation

D11 Features

Installation onto a 35 mm DIN rail

DC Product Specifications

Required Fiber Optic Cable

Adjustments SENSITIVITY control on top of module (15-turn slotted brass screw, clutched at both ends of travel)

Output Configuration Complementary: one normally open (N.O.) and the other normally closed (N.C.); Outputs are NPN(Sinking) or

PNP (Sourcing), depending on model

Output Rating 150 mA maximum (each output); The total load may not exceed 150 mA;

Off-state leakage current: <5 microamps at 30V dc;

On-state saturation voltage: <0.8V at 80 mA dc; <1.5V at 150 mA dc

Output Protection Circuitry Protected against false pulse on power-up (false pulse protection circuit causes a 0.1 second delay on

power-up); short-circuit protected

Output Response Time 500 microseconds "on" and "off"

Indicators Two LEDs: Green and Yellow

GREEN glowing steadily = power to sensor is "on"

GREEN flashing = output is overloaded

YELLOW glowing steadily = normally open output is conducting

YELLOW flashing = marginal excess gain (1-1.5x) in light condition = alarm output "on"

Repeatability Repeatablilty is 160 microseconds; Response time and repeatability are independent of signal strength

Construction Black ABS (Cycolac

KJB) flame retardent housing with acrylic cover; Stainless steel M3 x 0.5 hardware for use

with ABS (Cycolac

KJB) mounting bracket (supplied)

Environmental Rating IEC IP54; NEMA 2

Connections 2 m (6-1/2 ft) or 9 m (30 ft) attached cable, or 4-pin pico-style quick-disconnect fitting; Cables for QD

models are purchased separately

Operating Temperature -20º to +55ºC (-4º to +131ºF); Maximum relative humidity 90% at 50ºC (non-condensing)

PI or PB Series plastic fibers

Supply Voltage and Current 5V dc (±10%) at 25 mA (exclusive of load current)

Sensing Beam Visible red, 680 nm

Cycolac

is a registered trademark of General Electric Company

Yellow Output Indicator

Green Power “ON” Indicator

15-Turn Sensitivity

(Gain) Control

DIN Rail

1 2 3 4

Sin comentarios

Banner D11 Series Manual de usuario Pagina 2