Banner T-GAGE M18T Series Temperature Sensors Manual de usuario descargar pdf (Pagina 5)

Teaching Limits Using Dynamic TEACH

Dynamic TEACH is a method of setting the sensor’s threshold while the application is active. Dynamic TEACH will sense the high and

low temperature limits of the process and automatically set the threshold at the midpoint between these limits.

Dynamic TEACH Procedure Result

Push Button Remote Line

(0.04 sec < T < 0.8 sec)

Programming

Mode

• Push and hold

push button for 2

seconds

No action required

• Power LED turns Red

• Output LED turns Yellow

Enter Dynam-

ic TEACH

Process

• "Double-click" the

push button

• Double-pulse the remote line

T T

• Sensor begins dynamic learning

process

• Output LED flashes Yellow @ 2 Hz

End Dynamic

TEACH Proc-

ess

• "Single-click" the

push button

• Single-pulse the remote line

• Sensor ends data collection; sets

threshold

• Power LED turns Green

• Sensor returns to Run mode

Hot Operate/Cold Operate Select

The sensor can be configured for either Hot Operate or Cold Operate via the remote teach wire (gray). A series of three pulses on the

line will toggle between Hot and Cold Operation.

Procedure Result

Push Button Remote Line

(0.04 sec < T <

0.8 sec)

Toggle Between

Hot Operate / Cold

Operate

• Not available via push but-

ton

• Three-pulse the remote

line

T T

• Either Hot Operate or Cold Operate is selec-

ted, depending on previous condition

Push Button Lockout

The push button lockout feature enables or disables the push button to prevent unauthorized adjustment of the program settings.

Procedure Result

Push Button Remote Line

(0.04 sec < T < 0.8 sec)

Push But-

ton Lockout

Not available via push but-

ton

• Four-pulse the remote line

T T

T T T

T T

• Push button is either enabled or dis-

abled, depending on previous condi-

tion

Installation Notes

Align the sensor toward the object to be detected. Visually align if possible, or use the alignment device accessory listed in Additional

Accessories on page 9.

M18T T-Gage Sensor

P/N 120632 Rev. A www.bannerengineering.com - tel: 763-544-3164 5

1 2 3 4 5 6 7 8 9

Comentarios a estos manuales

Sin comentarios

Banner T-GAGE M18T Series Temperature Sensors Manual de usuario Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Banner T-GAGE M18T Series Temperature Sensors