Banner PVD100 Pallet Sensor Manual de usuario descargar pdf (Pagina 5)

Status Indicators/Troubleshooting

MODE

Status Indicator #1

Status Indicator #2

Figure 7. Status indicators

Indicator Condition Description

#1 Steady Yellow Output is active (Changing Switch #2 to N.C. turns the yellow indicator ON when the system is clear)

OFF Output is inactive (Changing Switch #2 to N.O. turns the yellow indicator ON when the system is blocked)

#2 Steady Green Power is ON and system is OK

Flashing Green Blanking is enabled

OFF Power is OFF

Specifications

Supply Voltage and Current

Input Voltage: 12 to 30V dc (10% maximum ripple at

10% duty cycle)

Input Current: Less than 40 mA @ 24V dc and less

than 70 mA @ 12V dc (exclusive of load)

Supply Protection Circuitry

Protected against reverse polarity and transient over-

voltages

Sensing Beam

Visible red, 630 nm

Sensing Range

Retroreflective applications: 2 m (6.5 ft) using 25

mm (1 in) wide retroreflective tape

Diffuse applications: 400 mm (15.7 in) with 18% re-

flectivity gray card target

Sensing Height

4-channel models: 111 mm (4.4 in)

8-channel models: 240 mm (9.4 in)

Beam Spacing

28.6 mm (1.125 in)

Output Configuration

User-selectable via DIP switch:

1 open-collector PNP (current sourcing) or 1 open-col-

lector NPN (current sinking)

Sensing Resolution

See Dimensions on page 6 for Minimum Object De-

tection Zone

Retroreflective: 51 mm at 406 mm range, 100 mm at

2 m (2.0 in dia. at 16 in range, 3.9 in at 6.5 ft); see

Figure 2. Minimum object detection size (retroreflective

operation) on page 2

Diffuse: 55 mm dia. at 400 mm range (2.16 in at 15.7

in range)

Indicators

Green LED: Power ON/OFF

Yellow LED: Output ON/OFF

Job Light (Diffused Green LED): Turned ON and OFF

by applying an external signal to the Job input (white

wire). The job lights will be active high or active low,

depending on DIP switch 4 selection.

Error Light (Diffused Red LED): Turned ON and OFF

by detection of an output event when job light is not

ON.

Adjustments

4 DIP switches, located behind access panel (default

setting is ON position)

Construction

Black painted aluminum housing; acrylic lenses; ther-

moplastic polyester end caps; thermoplastic elastomer

programming switch cover; stainless steel mounting

brackets and hardware

PVD Series Parts Verification Sensor

P/N 113230_web

Rev. E

www.bannerengineering.com - tel: 763-544-3164 5

1 2 3 4 5 6 7 8 9

Comentarios a estos manuales

Sin comentarios

Banner PVD100 Pallet Sensor Manual de usuario Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Banner PVD100 Pallet Sensor