Banner T30 Series Manual de usuario descargar pdf (Pagina 5)

S2 Series

Banner Engineering Corporation page 5

Product Specifications

Supply Voltage and Current

Opposed Mode Emitter

Opposed Mode Receiver

Polarized Retro

Fixed-field

Supply Protection Circuitry Protected against reverse polarity and transient voltages

Output Configuration Sensing Output: PNP (current sourcing), light operated

Output Rating 150 mA maximum (each); the total load may not exceed 150 mA;

Off-state leakage current <1 microamp at 30V dc;

On-state saturation voltage <1V at 10 mA dc; <1.5V at 150 mA dc

Output Protection Circuitry Protected against false pulse on power-up and continuous overload or short-circuit of outputs

Output Response Time Opposed: 3 milliseconds "on" and 1.5 milliseconds "off"

Polarized Retro and Fixed-field: 3 milliseconds "on" and "off"

NOTE: 100 millisecond delay on power-up; outputs are non-conducting during this time

Indicators Two LEDs: Green and Yellow

GREEN glowing steadily = power to sensor is "on"

GREEN flashing = output is overloaded

YELLOW glowing steadily = normally open output is conducting

YELLOW flashing = excess gain marginal (1-1.5x) in light condition

Repeatability Opposed: 375 microseconds

Polarized Retro and Fixed-field: 750 microseconds

Repeatability and response are independent of signal strength

Construction Housings are VALOX

thermoplastic polyester; Lenses are Lexan

(opposed models) or acrylic (retro and fixed-

field models) S18 and S30 come with two jam nuts; T18, T30, Q25 and Q40 come with one jam nut

Environmental Rating Leakproof design rated NEMA 6P; IEC IP67

Connections 4-pin euro-style quick-disconnect fitting; cables are ordered separately

Operating Temperature -40° to +70°C (-40° to 158°F); Maximum relative humidity 90% at 50°C (non-condensing)

Vibration and

Mechanical Shock

All models meet Mil. Std. 202F requirements. Method 201A (Vibration; frequency 10 to 60 Hz, max.,

double amplitude 0.06-inch acceleration 10G). Method 213B conditions H&I (Shock: 75G with unit

operating; 100G for non-operation)

10 to 30V dc (10% maximum ripple); Supply current (exclusive of load current):

25 mA

20 mA

30 mA

35 mA

Alarm Output: PNP (current sourcing), normally open

and conducts whenever the sensor's excess gain drops

to between 1X and 1.5X in the light condition

1 2 3 4 5 6 7 8

"S2" Series Sensors 1
S2 Series 2

Comentarios a estos manuales

Sin comentarios

Banner T30 Series Manual de usuario Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Banner T30 Series